How To Remove Your Sistaco Colour
Our Express Remover has been carefully formulated to safely and easily remove your nail colour. When used correctly, there will be no damage to your natural nail. However, if you don’t have our Express Remover you can remove your colour with 100% acetone.
How To Remove Using The Express Remover
Gently buff the surface of your colour to remove the top coat.
Apply the Express Remover taking care to avoid the skin.
Wait 2 to 3 minutes or until the colour stops bubbling.
Use a remover tool to gently push off the colour. Wipe away residue.
Take your time. Repeat steps 2 - 3 if required.
How To Remove Using 100% Acetone
Gently buff the surface of your colour to penetrate the top coat.
Saturate a cotton ball with 100% acetone. Hold to nail for 60 seconds.
Repeat step 2 if required. Wipe away residue. Now decide what colour to put on next!
How to remove using Rapid Removal Hub
Turn lid in an anti clockwise direction to remove.
Pour 5-20ml of 100% Acetone into the plastic insert provided and place into the ‘well’ of the hub. Replace the lid; fixing into position.
Using a nail file, gently file the top coat to break surface.
Turn on using the middle lower ON button. Small square lights will begin to flash, whilst your Rapid Remover heats. Once heated and ready for use the ‘Steam’ button will light up and you will hear a single beep. You can now insert your fingers into the top of the system as shown and grip the top slightly to allow the steam to better reach your nails. Be careful not to place fingers too low to avoid burning.
When the red indicator END light turns on, the steam process is completed by two beeps. Remove your fingers and gently push off your application using the Sistaco 3-in-1 nail tool. Do this immediately otherwise your nail application could harden again. If this happens you will need to repeat Step 4 again. After finishing wash your nails and moisturise.
CAUTION: Keep away from children.
Do not allow use without adult supervision. Remember to switch off and unplug your device when not in use. Do not pour Acetone directly into your ‘well’. You must use your plastic insert. If you pour directly into the well this will damage your Rapid Removal Hub