How To Apply Sistaco Holographic?

Answer

Verified

385k+ Views

Step 1
Wash nails with oil free soap to remove any oils. Dry thoroughly and buff nail lightly.

Step 2
For Long Wear
Apply a thin layer of Base Coat to the nail while avoiding the skin. Start to apply at the middle of the nail and push the Base Coat towards the cuticle; kind of gently scrub the Base Coat into the nail in order to get it into all the grooves. DO NOT set. Immediately apply a thin layer of Top Coat over the Base Coat, also ensuring avoidance of skin. Top Coat can be simply applied from base to tip of the nail plate; very finely.
For Short Wear:

Apply Top Coat to the nail while avoiding the skin. Top Coat is applied alone without Base Coat.

Step 3
Connect your LED Lamp, press and hold button on top for 3 seconds and set your nails until it automatically turns off (this should be 2 minutes).

Step 4
Gently dip either type of sponge applicator (if using Mineral Bond applicator , dip vertically) into powder to evenly coat . Rub applicator back and forth on to the nail. Repeat in thin layers if required.

Step 5
Gently apply a thin layer of Top Coat, making sure there is enough Top Coat on the applicator, so that you do not pull powder from the nail. Your brush should hardly touch the nail plate.

Step 6
Press and hold the button on the top for 3 seconds and set your nails until it automatically turns off (this should be 2 minutes). Remove excess powder with our 3 Way Brush; wash nails thoroughly to remove any excess. Dry thoroughly and condition daily with our Sistaco Elixir to help with longevity and keep your nails moisturised.